The first thing to do is to confirm the volume of the frame, then I will explain the way of cutting the borders. Take the most commonly used 3.5*90 profiles and P10 cell boards as an example. The display volume is 2 blocks of *5.
1. confirm that the size of the unit panel must be very accurate to millimeter. Take the P10 panel for example: its size is 16cm*32cm.
2. calculate the net size of the height and width of the unit panel in the display screen, for example, the height of the example is 2 *16cm=32cm wide and 32cm*5 block =160cm.
3. subtract 4mm from the calculated net dimension. As mentioned above, the net dimension is 32cm*160cm, and the aluminum dimension should be (32cm-4mm) * (160cm-4mm) =31.6cm*159.6cm. 31.6 and 159.6 are the actual dimensions of the aluminum material, and the screen should be less than 5mm for more than 3 meters.
4. connect the corners and cut sections with tapping, clean up the groceries thoroughly and put the front face down.
5. put the unit board in the direction, so you can't make a mistake in the direction. The place with a needle must be high in the profile.
6. install the magnet column onto the cell board and broadcast the magnetic disc into the concave of the nursery column.
7. measure the length of the light steel keel and put it on the magnet. Try to make the magnet in the center of the keel to avoid distance deviation.
8. the keel is used from tapping and framed.
9. use the wiring line to connect the unit board to the bridge type, so that the line can not be buttoned.
Related Industry Knowledge
- Introduction of outdoor LED screen
- Main features of outdoor LED screen
- Attention to outdoor LED screen
- The outdoor LED screen can take corresponding s...
- Installation attention
- The future development direction of LED display...
- Different development fields of LED electronic ...
- Installation of production process for LED disp...
- How will the led electronic screen industry dev...
- Standardization to maximize resource utilizatio...